Right Instrument Panel

Clock

clock

Mechanical wind-up clock.

The wind/set knob (1) is located on the lower left corner.

  • Rotate clockwise to wind the clock.
  • Pull out and rotate to set the hour and minute hands.

The elapsed-time control (2) is located on the upper right corner and is used to start, stop, and reset the 1-hour elapsed time counter.

ALR-67 Indicator

alr-67

Displays radar emitters detected by the ALR-67 radar warning receiver.

Threat Display Bands

  • Non-lethal band (2) - Displays emitters not considered an immediate threat due to range or lack of weapon capability.
  • Lethal band (3) - Displays emitters capable of engaging own aircraft but not currently doing so.
  • Critical band (4) - Displays direct threats to own aircraft. Systems capable of engaging own aircraft and showing current intent of doing so.

System Status Circle

The system status circle (1) is divided into three areas.

Area I (upper left quadrant) displays threat prioritization symbols:

  • N - Normal.
  • I - AI, Airborne interceptors prioritized.
  • A - AAA, Anti-air artillery prioritized.
  • U - Unknown emitters prioritized.
  • F - Friendly emitters displayed in addition to threats.

Area II (upper right quadrant) indicates limited mode status.

  • (Blank) - Limited mode not selected.
  • L - Limited mode selected. Only the six highest-priority threats are shown.

Area III (lower half) displays system status and offset information:

  • (Blank) - Normal operation.
  • B - BIT failure.
  • T - Thermal overload.
  • O - Offset display selected. Threats will be separated to allow readout of overlapping symbols. Bearing accuracy degraded for displaced threats.

Intensity Control Knob

The INT knob (5) adjusts display brightness.

Fuel Quantity Totalizer

fuel

The fuel quantity totalizer (1) displays total fuel quantity in all aircraft tanks.

Threat Advisory and Master Caution Lights

threat master

Master caution light and ECM/IFF advisory and warning indications.

The MASTER CAUTION light and reset button flashes to indicate a status change on the RIO caution/advisory panel.

Press to acknowledge and extinguish the light until the next event.

ALR-67 Caution Lights

IndicatorFunction
IFFAdvisory light indicating received mode 4 interrogation without own system generating a reply.
RCVAdvisory light indicating ALQ-126 is receiving a threat identification signal.
XMITAdvisory light indicating ALQ-126 is transmitting.
SAMWarning light, steady illumination when detecting lockon from a SAM tracking radar. Flashes when a missile launch is detected.
AAAWarning light, steady illumination when detecting lockon from a AAA tracking radar. Flashes when AAA engagement is detected.
CWWarning light indicating detection of a continuous wave emitter.
AIWarning light, steady illumination when detecting lockon from an airborne interceptor radar.

ALR-45 Caution Lights

IndicatorFunction
SA TRKLights steady whenever a SAM tracking radar is received.
SA2SA-2 warning - Lights steady for MA (missile alert), flashes for ML (missile launch).
SA3/NISA-3 / SA-N-1 warning - Lights steady for MA (missile alert), flashes for ML (missile launch).
SA4SA-4 warning - Lights steady for MA (missile alert), flashes for ML (missile launch).
AI/AAALights steady whenever an airborne interceptor and/or an ambiguous AI/AAA radar is received.
RECLights steady whenever ALQ-100 is receiving signal identified as threat.
IFFAdvisory light indicating received mode 4 interrogation without own system generating reply.
SA6SA-6 warning - Lights steady for MA (missile alert), flashes for ML (missile launch).
AILights steady whenever an airborne interceptor radar is received.
REPLights steady whenever ALQ-100 is transmitting.

Bearing Distance Heading Indicator (BDHI)

bdhi

Display indicating azimuth and bearing information.

No. 2 Bearing Pointer

The No. 2 bearing pointer (1) indicates magnetic course to the tuned TACAN station.

Compass Rose

The compass rose (2) indicates aircraft magnetic heading.

No. 1 Bearing Pointer

The No. 1 bearing pointer (3) indicates bearing to the tuned UHF/ADF station.

Distance Counter

The distance counter (4) indicates slant range to the tuned TACAN station in nautical miles.

(Not visible in the referenced image.)

Canopy Jettison Handle

canopy jettison

The canopy jettison handle (1) is used to manually jettison the canopy.